Maintenance And Cleaning - Parkside PDAP 75 A1 Traducción Del Manual De Instrucciones Original

Maintenance and cleaning

WARNING! RISK OF INJURY!
Disconnect the appliance from the compressed
air supply.
CAUTION!
► Before maintenance, clean off any hazardous substances that
may (due to working processes) have accumulated on the
appliance . Avoid all skin contact with these substances . If the
skin comes into contact with hazardous dusts, this can lead
to severe dermatitis . If dust is produced or swirled up during
maintenance, it can be inhaled .
NOTE
► To ensure correct functioning and long-term durability of the
compressed air polisher, pay attention to the following points:
■ Sufficient and continuously intact oil lubrication is highly
important for optimum functioning .
■ Check the speed and vibration levels after each use .
■ Check the idle speed regularly and after any maintenance is
performed:
use a rev counter and perform the measurement without any
clamped tools . At a residual pressure of 6 .3 bar, the idle speed
may not be exceeded under any circumstances .
■ If the appliance is exhibiting excessive vibration levels, the cause
of the vibrations must be identified and repaired .
■ Use only the genuine replacement parts recommended by the
manufacturer, otherwise you could put users at risk . In doubt,
contact the Service Centre .
■ 96 │ GB │ MT
PDAP 75 A1