Adjustments & Maintenance
Doors
The cabinet doors have a three-way adjustment feature.
Height, level, and fi t-to-frame can all be adjusted using a
#2 Phillips Head screwdriver.
■
HEIGHT: If the door is too high or low, adjust the door
down or up with screw #2 as shown in Figure M. This
screw is located inside the hinge and requires the door
to be opened approximately 90° to access the screw.
■
LEVEL: If the door is out of level or too close to one
side, adjust the door to the left or right using screw #1 as
shown in Figure M.
■
FIT-TO-FRAME: If the door opens stiffl y, squeaks, or
rubs against the gasket, adjust the door outwards with
screw #3 as shown in Figure M.
Figure M
HINGE
1 2
DOOR
ADJUST DOOR PITCH
SIDE-TO-SIDE
USING SCREW #1
Door "Swing"
Check the swing of the door. The door hinges come with
a 110° black
plastic hinge stop so they will not swing into
a light kit. If no light kit is installed, the stop is not neces-
sary and the door can be allowed to swing 170°. If hinge
stops are required, snap the
the hinge into the holes located on the hinge.
Night Light Electrical Option
Activate the night light by pressing the
on the outlet shelf. Once the night light is turned ON its
sensor will monitor the light in the room and turn itself
on (when the room gets dark) and off (when the room
gets light). Press the button again to turn the night light
OFF (the light will not come on until the button is pressed
again).
209-1090 MP and MT Cabinets 03/29/07
MOUNT OR
UNMOUNT
DOOR,
OR ADJUST
FORWARD OR
BACKWARD
USING SCREW #3
3
ADJUST DOOR
UP/DOWN
USING SCREW #2
hinge clip over the elbow of
button
WHITE
Electrical Option Doors with Defogger
To turn the defogger ON:
Press the
RED
minutes the center portion of the door will get warm.
To turn the defogger OFF:
Press the
RED
NOTE: Be sure to turn the defogger off
when not in use.
When the defogger is on, the center area of the mirror
(approximately 2 square feet [.1858 square meters]) will
remain fog-free. If the defogger does not function, check
the wiring to the outlet shelf. Do not attempt to repair the
door. There are no fi eld-serviceable parts. Contact the
factory or your dealer.
The GFCI receptacle(s) come equipped with a built-in
self test. Once a month, press the TEST button (then
RESET button) to assure proper operation. If the red
Light Emitting Diode (LED) begins to fl ash, the recepta-
cle has lost its GFCI protection, and should be replaced
by a qualifi ed licensed electrician.
Final Assembly
1. Insert clear snap-in Shelf Clips into
the holes on the sides of the cabinet.
See Figure N.
2. Push one side of the shelf into the left or right clip (A).
3. Snap the shelf down into the opposite side (B). If the
shelf is too tight, repeat the process starting from the
opposite side.
4. Install the Shelf Hole Plugs into the unused holes
inside the cabinet by pressing them into the holes.
5. Place the grey Screw Head Caps over any exposed
screw heads.
8
button on the outlet shelf. Within 3
button again.
Figure N
A
B