Robern MT Instrucciones De Instalación página 5

Mounting the Side Kit
The Side Kit is purchased separately from the cabinet.
It is used to fi nish the sides of a surface mounted or
partially recessed cabinet.
To install the Side Kit:
1. Attach Side Kit to sides of cabinet (top and bottom)
by threading #10 X ½" (12.7 mm) screws from inside
cabinet box into Side Kit as shown in Figure F.
(See Figure C on page 3 for
How to Recess Mount Cabinets
IMPORTANT!
The rough opening must be framed on all four
sides and at least 3 ¾" (95.2 mm) deep for D4
cabinets, 5 ¾" (146 mm) for D6 cabinets, and
7 ¾" (196.9 mm) deep for D8 cabinets (when
fully recessed).
When using an Electrical option for
NOTE:
recess mount cabinets, electric wire must be
roughed-in prior to installation (see "Wiring an
Electrical Option" on page 7).
1. Place the individual or connected boxes (see also
"How to Gang Mount Cabinets" on page 6) into the
rough opening and make sure the bottom is level.
For cabinets with an Electrical option: remove outlet
shelf and pull electric wire through the wire access
hole in rear of cabinet (see Figure C on page 3 and
"Wiring an Electrical Option" on page 7).
2. Install a #10 X 2" (50.8 mm) or #10 X 3" (76.2 mm)
Pan Head (SMS/ Wood Screw) screw through top
mounting hole in cabinet (see Figure C, page 3 for
hole locations) and screw into wall stud as show in
Figure G. Do not overtighten screw.
3. Determine that the cabinet is square and plumb,
then install a #10 X 2" (50.8 mm) or #10 X 3"
(76.2 mm) Pan Head (SMS/Wood Screw) screw
through bottom hole and screw into wall stud.
Do not overtighten screw.
NOTE
When partially recessing the cabinets (for example,
installing the 6" (152.4 mm) deep cabinet into a 4"
(101.6 mm) deep opening), follow the instructions
provided with the MPSK40-D2 or D4 Side Kit.
hole locations.)
CABINET
4. Place the grey Screw Head Caps over the screw
heads.
5. For cabinets with an Electrical option, make the elec-
trical connections (see "Wiring an Electrical Option"
on page 7 for more information).
6. If you are partially recessing the cabinet, install the
Side Kit (see page 5 for instructions).
7. Mount the doors following the instructions supplied
with the hinge and shown in Figure M on page 8.
Open and close the doors to check their operation.
8. If using an Electrical option, plug the cord for the
Electrical option door into the outlet shelf. Check for
proper operation of electric and the defogger and/or
night light. See "Adjustments and Maintenance" on
page 8 for help.
9. Install shelves as shown in "Final Assembly" on
page 8.
Figure G
CABINET
Poly-set Anchor Instructions
for Hollow Walls
1. Drill 9/32" (7.1 mm)
hole and insert anchor
until fl ange is fl ush.
2. Insert #10 X 2" (50.8 mm) SMS/Wood
screw through bracket and anchor.
Continue to turn
the anchor.
5
Figure F
SIDE
KIT
#10 X 2" (50.8 mm)
SMS/ WOOD
SCREW
2" X 4"
(50.8 mm X 101.6 mm)
WALL STUD
screw to fully expand
209-1090 MP and MT Cabinets 03/29/07