Tabla de contenido
Idiomas disponibles
Idiomas disponibles
SyMbolS
The label on your tool may include the following
symbols. The symbols and their definitions are
as follows:
V ..................volts
A ..................amperes
Hz ................hertz
W .................watts
min ..............minutes
or AC ......alternating current
.............direct current
n o ................no load speed
................Class I Construction
(grounded)
................Class II Construction
(double insulated)
................earthing terminal
................safety alert symbol
.../min or rpm...revolutions or
reciprocation per minute
..............Read instruction manual before use
.................Use proper respiratory protection
................Use proper eye protection
................Use proper hearing protection
fuNcTIoNAl deScRIPTIoN
1. Forward/reverse slider
2. Variable speed trigger
3. Attachment release button
4. Bit holder
SAve TheSe INSTRucTIoNS
ReAd All INSTRucTIoNS
operating Instructions
WARNING:
To reduce the risk of
serious personal injury, read, understand
and follow all safety warnings and
instructions prior to using tool.
WARNING:
It is important to support
the work properly and to hold the drill
firmly to prevent loss of control which
could cause personal injury. If you have
any questions on how to properly operate
tool, call: 1-800-544-6986.
WARNING:
To reduce the risk of injury,
always unplug from power supply before making
any adjustments or changing accessories.
WARNING:
To reduce the risk of injury, let
the tool work at its own pace. Do not overload.
When using an extension cord, be sure to use
one heavy enough to carry the current your
product will draw. An undersized cord will
cause a drop in line voltage resulting in loss
of power and overheating. The following table
shows the correct size to use depending on
cord length and nameplate ampere rating. If in
doubt, use the next heavier gauge. The smaller
the gauge number, the heavier the cord.
Minimum Gauge for cord Sets
volts
120V
0-25
(0-7,6m) (7,6-15,2m) (15,2-30,4m) (30,4-45,7m)
240V
0-50
(0-15,2m) (15,2-30,4m) (30,4-60,9m) (60,9-91,4m)
Ampere Rating
More Not more
Than Than
0 -
6
18
6 -
10
18
10 -
12
16
12 -
16
14
3
2
oPeRATING: PoWeR uNIT
TRIGGeR SWITch & foRWARd/ReveRSe
SlIdeR
The forward/reverse slider (1) is used to control
the direction the attachment's rotation. It is
located above the variable speed trigger (2). To
reverse the motor, release the trigger FIRST,
then push the slider to the right hand side of
the tool when viewing from the rear. After any
reversing operations, return lever to the forward
position. Never change the direction of rotation
while the motor is running.
• The Power Unit is turned ON and OFF
by pulling and releasing the trigger. The
farther the trigger is depressed, the higher
the speed of the Power Unit.
• A forward/reverse control slider determines
the direction of the tool.
• To select forward rotation, release the
trigger switch and depress the forward/
reverse control button to the left.
• To select reverse, depress the forward/
4
Total length of cord in feet
26-50
51-100
101-150
51-100 101-200
201-300
American Wire Gauge
16
16
16
14
16
14
12
Not Recommended
1
4
14
12
12
Tabla de contenido
