To Add Fuel; To Start And Stop; To Examine Before Start; To Start A Cold Engine - Husqvarna 325L Manual Del Usuario

6. Fill the fuel tank.

To add fuel

• Always use a fuel container with an antispill valve.
• If there is some fuel on the container, remove the
unwanted fuel and let the container dry.
• Make sure that the area near the fuel tank cap is
clean.
• Shake the fuel container before you add the fuel
mixture to the fuel tank.
To do a run-in
• During the first 10 hours of operation, do not apply
full throttle without load for extended periods.

To start and stop

To examine before start

1. Make sure that the product has no missing,
damaged, loose or worn parts.
2. Make sure that nuts, screws and bolts are tightened.
3. Make sure that the trimmer head is not damaged.
4. Make sure that the air filter is not clogged.
5. Make sure that the safety devices on the product is
not defective.
6. Make sure that the product has no fuel leaks.

To start a cold engine

1. Push the air purge bulb 10 times.
10
2. Pull the choke control up.
3. Hold the body of the product on the ground with your
left hand.
Do not step on the product. Pull the starter rope
handle slowly until you feel some resistance. Then
pull the starter rope handle with force.
Note: Do not pull the throttle trigger while you start
the engine.
4. Continue to pull the starter rope handle until the
engine starts or tries to start (max. 3 pulls). If the
engine starts or tries to start, push the choke control
down. Continue to pull until the engine starts. Wait
60 seconds after a start before you pull the throttle
trigger.
882 - 001 - 10.10.2018