Tabla de contenido
Idiomas disponibles
Idiomas disponibles
ENGLISH
Before using the machine, check that
your cutting path is free from sticks,
stones, wire and any other obstacles.
Only use the machine in the upright
position, with the cutting line near the
ground. Never switch the machine on
in any other position.
Do not overreach and to keep your
balance at all times. Always be sure of
your footing on slopes and walk, never
run.
Do not work on steep slopes. Work
across the face of slopes, not up and
down.
Move slowly when using the machine.
Be aware that freshly cut grass is
damp and slippery.
Never cross gravel paths or roads
while the machine is running.
Do not to touch moving hazardous
parts before the machine is
disconnected from the mains and the
moving hazardous parts have come to
a complete stop.
Never touch the cutting line while the
machine is running.
Do not put the machine down until the
cutting line has come to a complete
standstill.
Use only the appropriate type of
cutting line. Never use metal cutting
line or fishing line.
Be careful not to touch the line
trimming blade.
Take care to keep the mains cable
away from the cutting line.
Always be aware of the position of the
cable.
8
(Original instructions)
Keep hands and feet away from the
cutting line at all times, especially
when switching on the motor.
Never operate the machine with
damaged guards or without guards in
place.
Take care against injury from any
device fitted for trimming the filament
line length.
After extending new cutter line always
return the machine to its
normal operating position before
switching on.
Do not use the lawn trimmer (edge
trimmer), if the cords are damaged or
worn.
Keep extension cords away from
cutting elements.
Electrical safety
#
This machine is double insu-
lated; therefore no earth wire is
required. Always check that the
power supply corresponds to the
voltage on the rating plate.
If the supply cord is damaged, it must
be replaced by the manufacturer or an
authorised BLACK+DECKER Service
Centre in order to avoid a hazard.
Electric safety can be further improved
by using a highsensitivity 30 mA
Residual Current Device (RCD).
Using an extension cable
Always use an approved extension cable
suitable for the power input of this tool
(see technical data).
Tabla de contenido
