Tabla de contenido
Idiomas disponibles
Idiomas disponibles
7. After mounting the light, apply silicone caulking adhesive
(not included) completely around the perimeter of the
fixture (A) where the back meets the mounting surface to
prevent water from seeping into the junction box. Turn
power back on at circuit breaker and flip wall switch to ON
position.
CARE AND MAINTENANCE
To clean, turn OFF all power to circuit and clean surfaces with a mild, non-abrasive cleaner.
Bulb Replacement: Use 20-watt max. GU10 pin-base halogen bulbs, 7-watt max. GU10 pin-base
CFLs or 2-watt max. GU10 pin-base LEDs.
CAUTION: Turn OFF all power to work area at main circuit breaker or fuse box. DO NOT rely
on wall switch alone to turn off power.
TROUBLESHOOTING
PROBLEM
The light will not go on.
Fuse blows or circuit trips
when fixture is turned on.
5-YEAR LIMITED WARRANTY
If this product fails due to a defect in materials or workmanship within five (5) years from the date of
purchase, return it along with proof of date of purchase and it will be replaced with the same or
comparable model free of charge.
This warranty is void if damage or defect has resulted from accident, abuse, misuse or faulty repair.
This warranty gives you specific legal rights and you may have other rights that vary from state to
state.
IN NO EVENT WILL LIABILITY EXTEND TO ANY CONSEQUENTIAL, SPECIAL, INCIDENTAL
OR INDIRECT DAMAGES OF ANY KIND ARISING OUT OF THE USE OR MISUSE OF THIS
PRODUCT. SOME STATES DO NOT ALLOW THE EXCLUSION OR LIMITATION OF
INCIDENTAL OR CONSEQUENTIAL DAMAGES SO THE ABOVE EXCLUSION OR LIMITATION
MAY NOT APPLY TO YOU.
POSSIBLE CAUSE
1. No power.
2. Fixture may be wired
incorrectly.
3. Switch may be wired
incorrectly.
Crossed wires or power wire is
not grounded.
CORRECTIVE ACTION
1. Make sure lamp fixture is
plugged in and power is on.
2. Check wiring.
3. Check wiring.
Consult a certified electrician.
6
7
Tabla de contenido
