Select Charging Mode - GYS TECH 750 Manual Del Usuario

• Make sure the black wire ("-" pole connection) has not contact with the fuel line or
the battery.
• Connect the red wire ("+") to the positive ("+") pole of the battery and the black
wire ("-") to the vehicle chassis.
e- Charging of positive earthed battery:
• Make sure the red wire ("+" pole connection) has no contact with the fuel line or
the battery.
• Connect the black wire ("-") to the negative ("-") pole of the battery and the red
wire ("+") to the vehicle chassis.
Charging of a battery not connected to a vehicle
Connect the red wire ("+") to the positive ("+") pole of the battery and the black wire
("-") to the negative ("-") pole.
Connection to the vehicle battery ( cable with eyelet terminals=accessories n°12-13)
a- connect the red cable to the positive battery's pole.
b- connect the black cable to the negative battery's pole.
After charging, disconnected the battery charger from supply mains. Then remove the chassis
connection and the battery connection, in this order.

SELECT CHARGING MODE

After connection to the power supply, Select your charging mode with the button
After a full charge, if battery is not disconnected from the charger, it remains in float charge mode,
even if user switches it over to another mode. This protects battery from being damaged.
MODE 1 (7.2V/750mA)
Press the selection button
process is activated, the electronic system will automatically start the charging process with the
red LED displaying
smoothly, the red LED display
is fully charged up to 7.2V±0.25V. At this stage red LED display
display will turn on.
MODE 2 (14.4V/750mA)
Press the selection button
If no further process is activated, the electronic system will automatically start the charging
process with the red LED displaying
If this procedure runs smoothly, the red LED display
charging process, until battery is fully charged up to 14.4V±0.25V. At this stage LED display
will turn off and green LED display
to select Mode 1. LED display
and charging starts with a current of 750mA ±10%. If this procedure runs
will remain on during the entire charging process, until battery
to select Mode 2. The corresponding LED display
and charging starts with a current of 750mA ±10%.
will turn on.
will light up. If no further
will turn off and green LED
will remain on during the entire
.
will light up.
9