Tabla de contenido
Idiomas disponibles
Idiomas disponibles
INSTALLATION
For easy installation, select an existing light operated
by a wall switch for replacement.
For best performance, mount the fixture about 8
feet (2.4 m) above the ground. NOTE: If fixture is
mounted higher than 8 ft. (2.4 m), aiming the sen-
sor down will reduce coverage distance.
❒ Drill the holes needed
to mount the backplate
to the junction box.
Eave Mount
For under eave installation, the sensor head must
be rotated as shown in the next two steps for proper
operation and to avoid the risk of electrical shock.
For eave mount only:
❒ Rotate the sensor head towards the clamp screw
joint.
Joint Clamp
❒ Then rotate the sensor head clockwise 180° so the
controls face down.
If the sensor pops out of the ball joint, loosen the
clamp screw and push the sensor back into the ball
joint. Tighten the clamp screw when done.
or fuse.
❒ Remove the existing light fixture.
❒ Route the light control's wires through the large
❒ Connect the junction box wires to the light control
NOTICE: 5410 models with Flash Alert feature will
also have a wire loop which can be used to disable
the flash alert feature. This wire loop should not
be connected to any other wire.
White to White
Wall Mount
Control Switch
2
W
L
ire the
ight
WARNING: Turn power off at circuit breaker
gasket hole.
wires. Twist together and secure with a wire
connector.
Black to Black
Gasket
C
ontroL
Flash Alert - Activated
(Blue)
598-1303-01
Tabla de contenido
