Installation; Wall.mount; Eave.mount - Heath Zenith JourneyMan Serie Manual De Instrucciones

Installation

Caution: Before starting the installation, turn the power off at the
If you want to use the Manual Override feature you will need to install the fixture on a circuit controlled
by a switch. The lamps are packed in boxes, inside the lampheads. Open the lampheads by removing
the screws at the top. Use a clean cloth or the foam packing around the lamps to keep your fingers off
the lamps. Install the lamps in the right side of the sockets first, then the left. Close the lampheads and
continue the installation as shown below.
Wall Mount
❒
Loosen the thumbscrews holding the sensor
head and lampheads.
❒
Adjust the various parts so that the fixture
looks similar to this illustration.
❒
Finger tighten the thumbscrews at this time.
598-1188-02
CirCuit Breaker.
CAUTION: To Avoid Fire Or Burn Hazards:
• Allow fixture to cool before touching. The bulb and the fixture
operate at high temperatures.
• Keep fixture at least 3" (76 mm) from combustible materials.
Do not aim at objects closer than 3' (1 m).
• Use only type T 250W (max.) tungsten halogen 120 VAC
lamps.
Eave Mount
❒
Loosen the thumbscrews holding the sensor
head and lampheads.
❒
Adjust the various parts so that the fixture
looks similar to this illustration.
❒
Finger tighten the thumbscrews at this time.
-5-