Pressure Washer - Craftsman CMXGWFN061113 Manual De Instructiones

ENgLish
Pump
The manufacturer recommends using SIMPSON
®
POWERWASHER Pump Guard or equivalent when storing
the unit for more than 30 days and/or when freezing
temperatures are expected. SIMPSON
Pump Guard is environmentally friendly.
NOTE: Using pump guard helps provide proper lubrication
to the internal seals of the pump regardless of temperature
or environment.
NOTICE: Risk of property damage. Use only SIMPSON®
/ POWERWASHER® Pump Guard or equivalent. Other
products could be corrosive and/or contain alcohol
which may cause pump damage.
1. Turn off pressure washer and disconnect hoses
from pump.
2. Unscrew bottle valve from Pump Guard bottle and
remove seal.
3. Screw bottle valve back onto bottle.
4. Attach bottle to water inlet of pump.
5. Squeeze bottle to inject contents into pump.
6. With ignition switch off, simultaneously pull starter rope
and squeeze bottle. Repeat until protector fluid exits
pump outlet. NOTE: This step may require two people.

Pressure Washer

1. Drain all water from high pressure hose and wrap it onto
hose wrap.
2. Drain all water from the spray gun and wand by holding
spray gun in a vertical position with nozzle end pointing
down and squeezing trigger. Store in gun holder.
3. Wrap up and secure detergent siphon hose so it is
protected from damage.
Accessories

DANGER: Risk of fluid injection. When using
replacement spray wands or guns with this pressure
washer, DO NOT use a spray wand and/or spray gun/
wand combination that is shorter in length than what
was provided with this pressure washer as measured
from the nozzle end of the wand to the gun trigger.

WARNING: Since accessories, other than those
offered by CRAFTSMAN, have not been tested with
this product, use of such accessories with this tool
could be hazardous. To reduce the risk of injury, only
CRAFTSMAN recommended accessories should be used
with this product.
Recommended accessories for use with your tool are available
at extra cost from your local dealer or authorized service
center. If you need assistance in locating any accessory, please
contact CRAFTSMAN, call 1-877-362-4271.
14
® /
® / POWERWASHER ®
Repairs

WARNING:To assure product SAFETY and RELIABILITY,
repairs, maintenance and adjustment (including brush
inspection and replacement, when applicable) should
be performed by a CRAFTSMAN factory service center
or a CRAFTSMAN authorized service center. Always use
identical replacement parts.
To find the nearest service center, please contact CRAFTSMAN,
call 1-877-362-4271.
Cleaning

WARNING: Blow dirt and dust out of all air vents with
clean, dry air at least once a week. To minimize the risk
of eye injury, always wear ANSI Z87.1 approved eye
protection when performing this.

WARNING: Never use solvents or other harsh
chemicals for cleaning the non-metallic parts of the
tool. These chemicals may weaken the plastic materials
used in these parts. Use a cloth dampened only with
water and mild soap. Never let any liquid get inside the
tool; never immerse any part of the tool into a liquid.
Register Online
Thank you for your purchase. Register your product now for:
• WARRANTY sERViCE: Registering your product will
help you obtain more efficient warranty service in case
there is a problem with your product.
• CONFiRMATiON OF OWNERshiP: In case of an
insurance loss, such as fire, flood or theft, your registration
of ownership will serve as your proof of purchase.
• FOR YOUR sAFETY: Registering your product will
allow us to contact you in the unlikely event a safety
notification is required under the Federal Consumer
Safety Act.
Register online at www.craftsman.com/registration