GB - IMPORTANT SAFETY
INSTRUCTIONS
m
WARNING: follow these personal safety instructions
very carefully. Incorrect installation may create serious risks.
Save this manual for future reference.
• Read the instructions carefully before starting to install.
• This appliance can be used by children aged from 8 years and
above and persons with reduced physical, sensory or mental
capabilities or lack of experience and knowledge if they
have been given supervision or instruction concerning use
of the appliance in a safe way and understand the hazards
involved. Children shall not play with the appliance. Cleaning
and user maintenance shall not be made by children without
supervision.
• This product was designed and built strictly for the use
indicated in this documentation.
• Continuously monitor the gate while it is in motion and keep
all persons away from it until the door is completely opened or
closed.
• The manufacturer declines all liability in the event of incorrect
installation or improper use of the product.
• Warning: actuating the emergency release may cause
uncontrolled door movement.
• Frequently examine the installation, in particular check
cables, springs and mountings for signs of wear, damage or
imbalance. Check that the set screw on the last element of the
shutter is properly tightened. Do not use the equipment if it
requires repair or regulation.
• Before installing the drive check that the door is in good
mechanical condition and that it is correctly balanced. Check
that it opens and closes properly.
• Install the release control at a maximum height of 1.8 m.
• Any fixed controls must be installed within sight of the door
but away from moving parts. It must be installed at a height of
at least 1.5 m.
• Attach a label near the operating device, in a permanent
fashion, with information on how to operate the manual
release.
• Permanently fix a label warning against entrapment in a
prominent place or just near any fixed control.
• The motor cannot be installed on panels incorporating doors
(unless the motor can be activated when the door is open).
• Following the assembly please ensure that the door elements
do not project out on public footpaths or roads
• The drive is intended to be installed at least 2.5m above the
floor.
• Do not install the gearmotor in presence of fumes or
inflammable gas.
• The mechanical parts must conform to the provisions of
standard EN 12604.
• Manufacturer is not responsible for failure to observe good
technique in the construction of the closing elements to be
motorised, or for any deformation that may occur during use.
• The installation must conform to standard EN 12453.
• WARNING: Before start any job on the system, cut out electrical
power.
• The mains power supply of the automated system must be
fitted with an all-pole switch with contact opening distance of
3mm. Use of a 6 A thermal breaker with all-pole circuit break is
recommended.
• Make sure that the earth system is perfectly constructed.
• The safety devices (photocells , etc.) protect any danger
areas against mechanical movement risks, such as crushing,
dragging, and shearing.
• Use of at least one indicator-light is recommended for every
system, as well as a warning sign, in addition to the safety
devices.
• Do not command more than one gearmotor with each button.
• For maintenance, exclusively use original parts.
• Do not in any way modify the components of the automated
system.
• The mains cable must only be replaced by the manufacturer,
customer service or another qualified person. For connection to
the mains power supply, use a multicore cable with a cross-
section between 3x0.75mm
• The installer shall supply all information concerning manual
operation of the system in case of an emergency, and shall
hand over to the user the warning handbook supplied with the
product.
• Apply safety devices that meet standard EN 12978 to provide
full protection against impact, crushing and shearing in
conformity with the provisions of standard EN 12453.
• The installation must include a fall arrest system for the shutter,
such as the parachute shown in the instructions.
• Do not allow children or adults to stay near the product while it
is operating.
• Keep radio controls or other pulse generators away from
children, to prevent the automated system from being
activated involuntarily.
• The user must not attempt any kind of repair or direct action
whatever and contact qualified personnel only.
• Transit is permitted only when the automated system is idle.
• Maintenance: check at least every 6 months the efficiency of
the system.
• Sound emission: LpA ≤ 70dB;
• Anything not expressly specified in these instructions is
not permitted.
- 3 -
2
and 3x1.5mm
2
.
