Replacing The Power Fuses; Cleaning Cycle; Printer User Guide - Selecta AUTESTER ST DRY PV B 12L Manual De Instrucciones

INSTRUCTION MANUAL CODE 80369 REV 0
J
.P. SELECTA s.a.u.
JULY/2018

8.5 Replacing the power fuses

To replace the power fuses, do the following:
1. Switch the power off. Unscrew the fuse holder with a screwdriver counter clock-
wise.
2. Pull the fuse holder out with your fingers.
3. Make sure to replace the fuse by a suitable one.
4. Put back the fuse holder and lock it by turning it clockwise with a screwdriver.

8.6 Cleaning cycle

Every 100 cycles the equipment will indicate us that it needs a washing cycle. So, the
two TEST key leds will blink.
1. When the tank is empty, with no material inside, pulse SELECT for more than 5
seconds until "CLE" appears on the screen.
2. Press START and wait for 30 minutes, the equipment will make the cleaning cycle
automatically. Once finished, the equipment will work normally again.

8.7 Printer user guide

According to the requirement of customer, steam sterilizer can adopt prescriptive
printer. Connect the printer and the steam sterilizer with prescriptive cord. Switch on
the power, two lights on the printer panel will go on, and this means that the printer
has been installed.
Caution: steam sterilizer can only select micro.
Printer offered by us.
Print information explaining:
Date: Sterilize date.
CN: Name of the cycle.
C.S.T.: The starting time of the cycle.
Vp1.Vp2.Vp3: Vacuum pressure1, Vacuum pressure2, Vacuum pressure3.
Pp1.Pp2.Pp3: The phase of pressure1, the phase of pressure2, the phase of pressure3.
If you have activated the printing option at the end of the cycle, when the cycle fin-
ishes, the display will show "Ed" and at the same time "Prt" will appear, which means
that the information is sent to the printer.
Autovía A2 Km 585.1 Abrera 08630 (Barcelona) España
e-mail: [email protected] - website: http://www.jpselecta.es
(It can be modified without notice)
Tel 34 937 700 877 Fax 34 937 702 362
Page: 26