CAME MR8534 Manual Del Instalacion página 6

1
MOUNTING THE PROFILE
Mount the profi les as close as possible to the closing edge. Leave 2 cm
for the black end caps. Take the position of the white clips into account
before drilling and fastening the screws.
2
POSITIONING THE MODULES
3
WIRING
12-24 V
AC-DC
COM
NC
NO
*
COM
NO
NC
*
* Output status when sensor is operational
** For compliance with EN 16005 and DIN 18650, connection to door controller test output is required.
*** If door controller is not tested: conncect BLUE to 0 V and RED to +12 V - 30 V DC.
2 cm
GREEN
BROWN
POWER SUPPLY
YELLOW
WHITE
STOP IMPULSE
Opening side of door
BLACK
PINK
GREY
REOPENING IMPULSE
Closing side of door
VIOLET
RED**
TEST OUTPUT***
BLUE**
To loosen the modules, please use
a screwdriver.
The transmitter (TX) should be placed next to
the door edges that need to be protected.
The angle adjustment clip should be next to
the transmitter.
Turn the module if necessary.
When a module needs to be turned:
1. detach the clips
2. turn them by 180°
3. reattach
The module connected to the door controller
becomes the MASTER.
NO POWER
NO DETECTION
DETECTION
Plug the SLAVE
CABLE between
the modules in
one of the two
placements.
NO NC