Disposal Information - Flex XS713 Instrucciones De Funcionamiento Originales

Random orbit sander XS713
How to hold sander
Model XS713 is designed to be held around
the main housing, Ñig. 6.
Sanding procedure
The normal weight of the machine
is sufficient for efficient sanding. Do not put
additional pressure on the machine. This
would only slow down the speed of the pad,
reducing the sanding efficiency and put an
additional burden on the motor. In addition, it
might cause the sander to jump on the work.
Let the sander do the work.
Maintenance
Keep tool clean!
Periodically blow out all air passages with
dry, compressed air. Remove buildup
of grime resulting from working with green or
sappy wood. All plastic parts should
be cleaned with a soft damp cloth.
NEVER use solvents to clean plastic parts.
CAUTION!
Wear safety glasses while using compressed
air!
Failure to Sart
Should your tool fail to start, check to make
sure the prongs on the cord plug are making
good contact in the outlet. Also, check for
blown fuses or open circuit breakers in the
line.
Brush inspection and lubrication
At approximately 200 hours of use, take
or send your tool to your nearest Authorized
FLEX Power Tool Service Agent to
be thoroughly cleaned and inspected; worn
parts replaced, when necessary; relubricated
with fresh lubricant, if required; reassembled
with new brushes; and performance tested.
Any loss of power before the above main-
tenance check may indicate the need for
immediate servicing of your tool. DO NOT
CONTINUE TO OPERATE TOOL UNDER
THIS CONDITION. If proper operating voltage
is present, return your tool to an Authorized
FLEX Power Tool Service Agent for immediate
service.
Service and repairs
All quality tools eventually require servicing or
replacement of parts due to wear from normal
use. These operations, including brush
inspection and replacement, should ONLY be
performed by an Authorized FLEX Power Tool
Service Agent. All repairs made by these
agencies are fully guaranteed against
defective material and workman-ship. We
cannot guarantee repairs made or attempted
by anyone other than these agencies. Should
you have any questions about your tool, feel
free to write us at any time. In any
communications, please give all information
shown on the nameplate of your tool (model
number, type, serial number, etc.).

Disposal information

WARNING!
Render redundant power tools unusable
by removing the power cord.
EU countries only
Do not throw electric power tools
into the household waste!
In accordance with the European
Directive 2012/19/EU on Waste Electrical
and Electronic Equipment and transposition
into national law used electric power tools
must be collected separately and recycled in
an environmentally friendly manner.
NOTE
Please ask your dealer about disposal
options!
11