Carbon Brushes; Spare Parts And Accessories; Disposal Information - Flex FS 3403 VRG Manual De Instrucciones

Renovation milling machine FS 3403 VRG

Carbon brushes

The renovation milling machine features
cut-off carbon brushes.
When the cut-off carbon brushes reach their
wear limit, the renovation milling machine
switches off automatically.
Note!
Use only original parts supplied by the
manufacturer for replacement purposes.
If non-original parts are used, the guarantee
obligations of the manufacturer will be
deemed null and void.
When the angle grinder is being used,
the carbon brushes can be seen sparking
through the rear air inlet apertures.
If the carbon brushes spark excessively,
switch off the angle grinder immediately.
Take the angle grinder to a customer service
workshop authorised by the manufacturer.
Gears
Note!
Do not loosen the screws on the gear
head (3) during the warranty period.
Non-compliance will deem the guarantee
obligations of the manufacturer null and
void.
Repairs
Repairs may be carried out by an authorised
customer service centre only.

Spare parts and accessories

Spare-part/Accessory
Bail handle
Milling wheel (12 pc./set)
– pointed
– flat
Milling head, complete
– with milling wheel, pointed
– with milling wheel, flat
Guide table
Other accessories can be found in the
manufacturer's catalogues.

Disposal information

Danger!
Render redundant power tools unusable
by removing the power cord.
EU countries only
Do not throw electric power tools
into the household waste!
In accordance with the European Directive
2002/96/EG on Waste Electrical and
Electronic Equipment and transposition into
national law used electric power tools must
be collected separately and recycled in an
environmentally friendly manner.
Note!
Please ask your dealer about disposal
options!
Order
no.
298.506
333.700
333.719
333.689
333.697
333.778
19