Best WBF4I Manual De Instrucciones página 15

11. Remove the upper flue from inside the
lower flue. Install the lower flue bracket to
the lower flue using (2) flue bracket screws
#8 x 3/8". Make sure that the slots are at
the top. Carefully replace the upper flue
inside the lower flue, with the upper flue
recirculation slots and (2) bracket holes on
top. Remove protective plastic film covering
the lower flue only.
12. Carefully place both flues on top of hood.
Tabs on bottom edge of lower flue fit into slots on top of hood.
13. Attach non-duct plenum with collar to upper flue using (4) #8 x 3/8" Pan Head screws.
14. Hold hood up close to wall
mounting location and plug
power cord into wall outlet.
15. Align the hood and center
it above the hood mounting
bracket. Gently lower
the hood until it securely
engages the bracket.
16. With the hood hanging in
place, drill through both holes
located in the inside lower
back of hood using a 5 ⁄16"
dril bit. Insert the included
drywall anchors into the
drilled holes (one for each
hole). Install (2) washers and (2) #8 x 1-1/2" mounting screws through the back of
the hood and into the drywall anchors. Verify that the hood is centered and leveled.
Tighten all screws completely.
17. Attach (2) two non-duct recirculation
filters to sides of blower by aligning key
lock slot and rotating until filters lock
into place.
For replacement non-duct recirculation
filters - purchase S97018030 or
ROUNDFILTER.
18. Reinstall grease filters by aligning rear
filter tabs with slots in the hood. Push down the metal
latch tab, push filter into position and release. Make
sure filters are securely engaged after installation.
19. Slide up the upper flue until it is aligned with its
mounting
bracket. The bracket should be inside the flue.
Secure the upper flue on the upper flue mounting
bracket using (2) #8 x 3 ⁄8" mounting screws.
20. Remove protective plastic film covering the flue and
the hood.
LOWER FLUE MOUNTING BRACKET
I
NSIDE BACK
OF THE HOOD
S
IDE VIEW
H
OLES LOCATION
- 15 -
LOWER
FLUE
M /B
OTOR LOWER
ASSEMBLY
Ø5/16"
TYP
UPPER FLUE
MOUNTING BRACKET
FRONT VIEW
UPPER
FLUE
.