Extension Pole & Hook - Sperian Miller Manual Del Usuario

3.3 Extension Pole & Hook (475)
The Extension Pole & Hook Anchorage Connector is designed to provide a single user with an
easily installed anchorage connector. The 20 ft. (6m) fiberglass pole and spring-loaded hook is
ideal for climbing ladders and towers. It installs fall arrest systems up to 20 ft. (6m) from ground
level to angle iron, piping, small I-beams and related structures.
Warnings and Limitations
• For use by ONE person only. Maximum capacity is 400 lbs. (181.4kg), including tools. —
DO NOT EXCEED THIS WEIGHT.
• Use only locking carabiners, locking snap hooks or other Miller approved connectors or
connecting devices to attach to this equipment.
• The structure that this product is attached to must be capable of supporting a 5,000 lb.
(22.2kN) static load or provide a 2:1 safety factor in the direction of pull.
Hook (#475-1)
Fig. 3a
Attachment Ring
Installation
1. Attach the hook to the extension pole by inserting it into the receiver and aligning the pin with
the hole which will lock it in position. Adjust pole to the desired length by twisting the sections
of pole to release the locking mechanism. Once adjusted to the desired length, twist the pole
sections again to activate the locking mechanism.
2. Attach connecting device to the attachment ring using a locking carabiner, locking snap hook
or other Miller approved connector only.
3. Install the hook by pushing it over the approved anchorage and rotating it 90 degrees (see
Fig. 3a & 3b). Both halves of the hook must come together for proper attachment to the
anchorage.
WARNING: Connect to the attachment ring only.
Removal: To remove the device, simply reverse the installation procedure.
E n gli sh
Anchorage
Receiver
Fig. 3b
Extension Pole
(#475-2)
8
Installation Tabs