Miller Shadowlite Beam Anchor - Sperian Miller Manual Del Usuario

3.6 Miller ShadowLite
The Miller ShadowLite Beam Anchor is designed to provide a single user with an easily installed
anchorage connector on W-shaped and other flanged beams. This ratcheting beam anchor is
designed to trail freely behind a worker on beams with flanges from 3" (76mm) to 14" (355mm)
wide and up to 1¼" (31.7mm) thick.
Warnings and Limitations
• For use by ONE person only. Maximum capacity is 400 lbs. (181.4kg), including tools. —
DO NOT EXCEED THIS WEIGHT.
• Use only locking carabiners, locking snap hooks or other Miller approved connectors or
connecting devices to attach to this equipment.
• This device must only be attached to overhead beams at back D-ring level or higher.
• This device must only be used on beams where a fall will not cause the device to slide
along the beam and increase the fall distance.
• The device shall be connected such that it will not slide off the end of a beam and
should not be attached to a beam which is inclined or sloped greater than 15° from
horizontal.
• The structure that this product is attached to must be capable of supporting a 5,000 lb.
(22.2kN) static load or provide a 2:1 safety factor in the direction of pull.
E n gli sh
Beam Anchor (8816-14)
™
Fig. 6a
11