General Requirements, Warnings And Limitations - Sperian Miller Manual Del Usuario

Thank You
You have just acquired Personal Protective Equipment ( PPE ) and we thank you for your
confidence.
WARNING
All persons using this equipment must read, understand and follow all instructions.
Failure to do so may result in serious injury or death. Do not use this equipment un-
less you are properly trained.
IF THE BUYER IS NOT THE END USER, IT IS IMPORTANT
THAT THESE INSTRUCTIONS ARE GIVEN TO THE END USER.
Activities carried out at a height are dangerous and can result in serious accidents and
injuries. Please bear in mind that you are personally responsible in case of an accident,
injury or fatality to either yourself or a third party during or following the use of one of our
products. It is recommended that training in the use of our products is carried out under
the supervision and instruction of a competent and experienced person. Ensure that you
have been adequately trained in the use of this PPE and make sure that you have fully
understood how it works. If you are in any doubt, do not take any risks but seek advice.
Good physical condition is necessary in order to carry out work at a height. Certain medi-
cal conditions can endanger the safety of the user during normal use of personal protec-
tive equipment and in case of emergency (taking medication, cardiovascular problem,
pregnancy, etc.). If you have any doubts, ask your doctor.
1.0 General Requirements,
War nings and Limitations
All warnings and instructions shall be
provided to authorized persons/users.
All authorized persons/users must
reference the regulations governing
occupational safety, as well as applicable
NBR standards. Please refer to product
labeling for information on specific
standards met by these products.
Proper precautions should always be taken to
remove any obstructions, debris, material, or
other recognized hazards from the work area
that could cause injuries or interfere with the
operation of the system.
All equipment must be inspected before
each use according to the manufacturer's
instructions.
To minimize the potential for accidental
disengagement, a competent person must
ensure system compatibility.
E n gli sh
Equipment must not be altered in any way.
Repairs must be performed only by the
manufacturer, or persons or entities authorized
in writing by the manufacturer.
Any product exhibiting deformities, unusual
wear, or deterioration must be immediately
discarded.
Any equipment subject to a fall must be
removed from service.
The authorized person/user shall have a rescue
plan and the means at hand to implement it
when using this equipment.
Never use fall protection equipment for
purposes other than those for which it was
designed.
3