Using The Power Management System - Ingersoll Rand 2115P4Ti Instrucciones

USING THE POWER MANAGEMENT SYSTEM

WARNING
Impact Wrenches are not torque wrenches. Connections
requiring specific torque must be checked with a torque
meter after fitting with an impact wrench.
POWER MANAGEMENT SYSTEM
POWER SETTING INDICATORS
MINIMUM
Ingersoll-Rand No. 10 Oil
Ingersoll-Rand No. 115-1LB for routine external lubrication
of the impact mechanism through the Hammer Case Grease
Fitting.
MAXIMUM
POWER
INDICATOR
(Dwg. TPD1339)
LUBRICATION
The 2115P4Ti Impact Wrench incorporates a Power
Management System that allows the operator to select four
power output settings. These settings range from minimum
power output through maximum power output in the
clockwise direction only. The Air Wrench will always operate
at maximum power output in the counterclockwise direction,
no matter what power output level is selected. The four power
setting indicators of increasing size on the rear of the housing
indicate increasing power output levels, are for reference only
and DO NOT denote a specific power output. The smallest
power setting indicator designates minimum power output,
the two middle power setting indicators denote medium
power outputs and the largest power setting indicator denotes
maximum power output. The power output can be further
reduced in clockwise or counterclockwise by using the
variable throttle. Air supply systems which do not deliver
adequate air pressure can affect power output at all settings.
Use Ingersoll-Rand No. 105-1LB when disassembling and
assembling the impact mechanism.
Always use an air line lubricator with these tools. We
recommend the following Filter-Regulator-Lubricator (FRL)
Unit:
Inside USA use FRL Unit # C18-03-FKG0-28
Outside USA use FRL Unit # C18-C3-FKG0
3 Form P7748 Edition 1