Tabla de contenido
Idiomas disponibles
Idiomas disponibles
840205500 ENv02.qxd:Layout 1
Troubleshooting
PROBLEM
There is no display visible
on the control panel.
Food is undercooked.
The food isn't done after
cooking the amount of time
recommended in my recipe.
My meal was overcooked.
Why?
Gasket is/has flattened or
food seeps from under
gasket.
10
6/29/11
11:35 AM
Page 10
PROBABLE CAUSE
• Is the unit plugged in?
• Is the unit turned on? Display should flash SEL.
• Test that the electrical outlet is working with a lamp in known working order.
• Was power interrupted (due to brownout, electrical storm, etc.) for 5 seconds or longer?
• Was food cooked on the WARM setting? Do not cook on WARM setting; always cook on LOW or HIGH
heat settings.
• Was power interrupted (due to brownout, electrical storm, etc.) for 5 seconds or longer?
NOTE: For a power interruption of 5 seconds or less, the slow cooker will remember the programmed
heat and time settings.
• Did you select the LOW heat setting, but used a cooking time based on the HIGH heat setting?
• Did you have the glass lid placed correctly on the slow cooker?
• This can be due to voltage variations (which are commonplace everywhere) or altitude. The slight
fluctuations in power do not have a noticeable effect on most appliances. However, they can alter
cooking times in the slow cooker by extending the cooking times. Allow sufficient time and select the
appropriate heat setting. You will learn through experience if the shorter or longer time is needed.
• Was the crock at least half full? The slow cooker has been designed to thoroughly cook food in a filled
crock. If the crock is only half-filled, check for doneness 1 to 2 hours earlier than recipe time.
• Did you select hours based on a LOW heat recipe?
• Foods will continue to increase in temperature after desired temperature has been reached.
• Clips are for transportation purposes only. Do NOT use clips during cooking or storage.
Tabla de contenido
