Tabla de contenido
Idiomas disponibles
Idiomas disponibles
7. Canopy Assembly.
Locate 2 screws on underside of hanging bracket
and remove screw closest to the open end of the
hanging bracket. Partially loosen the other screw.
Lift canopy to hanging bracket. Place rounded part
of slotted hole in canopy over loosened screw in
hanging bracket and push up. Twist canopy to
lock. Re-insert screw that was removed and then
tighten both screws securely.
8. Blade Assembly.
Time Saver: Washers for blade screws can be
set on each blade screw prior to installing
blades.
Locate 15 blade attachment screws and washers
in hardware pack. Hold blade arm up to blade
and align holes. Insert 3 blade attachment screws
(along with washers) with fingers first and then
tighten screws securely with a Phillips
screwdriver. Repeat for the remaining blades.
Remove blade arm screws and lock washers from
underside of motor. If plastic motor locks are
installed with blade arm screws, discard plastic
motor locks (save blade arm screws and lock
washers to secure blade arms). Align blade arm
holes with motor screw holes and attach blade
arm with lock washers and blade arm screws.
Before securing screws permanently, repeat with
remaining blade arms. Securely tighten all screws.
Note: Tighten blade arm screws twice a year.
9. Light Kit Assembly (Optional).
If you wish to use your fan WITHOUT the light kit,
please proceed to Section 10 on page 8 to complete
installation WITHOUT the light kit.
If you wish to use fan WITH the light kit, remove
3 screws from switch housing and remove switch
housing cap.
Locate BLUE (or BLACK) and WHITE wires in switch
housing labeled FOR LIGHT. Remove and discard
plastic that holds these two wires together.
["Light Kit Assembly" continued on next page.]
canopy
screw
motor housing
plastic
motor lock
lock washers
switch
housing
black) wire
page 6
hanging bracket
screw
blade arm
blade arm screws
white wire
blue (or
switch housing cap
blade
motor
housing
Capítulos
Tabla de contenido
