Testing Your Fan - Craftmade CCU52 Guia De Instalacion

10. Testing Your Fan.

It is recommended that you test fan before finalizing
installation. Restore power from circuit box and light
switch (if applicable). Test fan speeds with the pull
chain on the switch housing. Start at the OFF
position (no blade movement). First pull will set the
fan to HI. Second pull will set the fan to MEDIUM.
Third pull will set the fan to LOW. Fourth pull will
again set the fan to the OFF setting. Test lights with
the pull chain in the middle (diagram 1). If fan
and/or lights do (does) not function, please refer to
"Troubleshooting" section to solve any issues before
contacting Customer Service.
Turn fan completely off before moving the reverse
switch (located on switch housing). Set reverse
switch to recirculate air depending on the season:
- DOWN position in summer (diagram 2)
- UP position in winter (diagram 3)
A ceiling fan will allow you to raise your thermostat
setting in summer and lower your thermostat setting
in winter without feeling a difference in your
comfort.
Important: Reverse switch must be set either
completely UP or completely DOWN for fan to
function. If the reverse switch is set in the middle
position (diagram 4), fan will not operate.
Attach pull chain extensions supplied or custom pull
chain extensions (sold separately) to ends of the pull
chains.
reverse
switch
light pull
chain extension
diagram 1
diagram 2
page 8
motor
housing
switch
housing
fan pull
chain extension
diagram 3 diagram 4