Tabla de contenido
Idiomas disponibles
Idiomas disponibles
SPECIFICATIONS
Range . . . . . . . . . . . . . Up to 60 ft. (18.3 m); [varies with
Sensing Angle . . . . . . . Up to 110°
Electrical Load . . . . . . . Up to 150 Watts Maximum
Power Requirements . . 120 VAC, 60 Hz
Operating Modes . . . . . TEST, AUTO and MANUAL
Time Delay . . . . . . . . . 1, 5, or 10 minutes
Sensitivity . . . . . . . . . . Adjustable
Replacement lamp . . . . T3 150W (or less) halogen 120
HeathCo LLC reserves the right to discontinue prod-
ucts and to change specifications at any time without
incurring any obligation to incorporate new features
in products previously sold.
SYMPTOM
POSSIBLE CAUSE
Light will not
1. Light switch is turned off.
come on.
2. Halogen lamp is loose or burned
out.
3. Fuse is blown or circuit breaker is
turned off.
4. Daylight turn-off is in effect (Recheck
after dark).
5. Incorrect circuit wiring, if this is a new
installation.
6. Not aimed correctly (Re-aim the
sensor to cover desired area).
Light comes on
1. Light control may be installed in a
in daylight.
relatively dark location.
2. Light control is in TEST (Select 1, 5
or 10 minutes for AUTO time).
Light comes on
1. Light control's sensor may be detect-
for no apparent
ing small animals, swaying trees, or
reason.
automobile traffic (Re-aim sensor).
2. Sensitivity is set too high (Reduce
sensitivity).
204022-02
surrounding temperature]
tungsten
MODE
VAC
TROUBLESHOOTING GUIDE
SYMPTOM
POSSIBLE CAUSE
Light stays on
1. The halogen lamp is positioned too
continuously.
close to the light control's sensor or
pointed at nearby objects that cause
heat to trigger the sensor (Reposition
the lamp away from the sensor or
nearby objects).
2. Light control's sensor is pointed toward
a heat source like an air vent, dryer
vent, or brightly-painted heat-reflective
surface (Reposition sensor).
3. On-time set too high (Reduce Time
setting).
Light flashes
1. Heat or light from the halogen lamp
on and off.
may be turning the light control on
and off (Reposition the lamp away
from the sensor).
2. Heat being reflected from other
objects may be affecting the light
control (Re-aim sensor).
3. Light control is in the TEST mode
and warming up (Flashing is normal
under these conditions).
5
Tabla de contenido
