Tabla de contenido
Idiomas disponibles
Idiomas disponibles
Mode Switching Summary
TEST
AUTO
MANUAL MODE
* If you get confused while switching modes, turn the
power off for one minute, then back on. After the
calibration time (1
/
minutes) the control will be in
1
2
the AUTO mode.
INSTALLATION
CAUTION: Keep the sensor at least 1" (25 mm)
away from the bulbs.
CAUTION: To Avoid Fire Or Burn Hazards:
• Allow fixture to cool before touching. The bulb and
the fixture operate at high temperatures.
• Keep fixture at least 2" (51 mm) from combustible ma-
terials. Do not aim at objects closer than 3 feet (1 m).
• Use only T3, 150W (maximum) tungsten halogen
120 VAC lamps.
For easy installation, select an existing light operated
by a wall switch for replacement. IMPORTANT: Do NOT
use with dimmers or timers.
For best performance, mount the fixture about 8 feet
(2.4 m) above the ground. NOTE: If fixture is mounted
higher than 8 feet (2.4 m), aiming the sensor down will
reduce coverage distance.
• Drill out the holes if needed
to mount the back plate to the
junction box.
Move ON-TIME Switch
to 1, 5, or 10 minutes
Flip switch off for
one second then
back on*
CAUTION: The sensor must be mounted
below the lamp housing for wall installations.
Wall Mount
NOTE: Light fixture and sensor should be mounted as
shown above when installed (depending upon type of
installation).
Before installing the light fixture under an eave, the
sensor head must be rotated as shown in the next
two steps for proper operation and to avoid the risk of
electrical shock.
For eave mount only:
1. Rotate the sensor head towards the clamp screw
joint.
Clamp Screw
2. Then rotate the sensor head counterclockwise
180° so the controls face down.
Controls
If the sensor pops out of the ball joint, loosen the
clamp screw and push the sensor back into the ball
joint. Tighten the clamp screw when done.
2
Eave Mount
Controls
204022-02
Tabla de contenido
