Tabla de contenido
Idiomas disponibles
Idiomas disponibles
Anleitung_TE_CC_315_U_SPK8__ 19.11.12 15:56 Seite 29
familiar with the tool or who have not read these
instructions to use the tool. Electric tools are
dangerous if they are used by inexperienced
people.
Keep your cutting tools sharp and clean.
n
Carefully maintained cutting tools with sharp
cutting edges will jam less and are easier to
control.
If the connection lead on the electric tool is
n
damaged, it must be replaced by a specially
prepared connection lead available from our
customer service organization.
Have your tool repaired only by trained personnel
n
using only genuine spare parts. This will ensure
that you tool maintains its safety standard.
The machine has to be set up where it can stand
n
securely.
All covers and safety devices have to be properly
n
fitted before the machine is switched on.
It must be possible for the blade to run freely.
n
When working with wood that has been
n
processed before, watch out for foreign bodies
such as nails or screws etc.
Before you actuate the On/Off switch, make sure
n
that the saw blade is correctly fitted and that the
machineʼs moving parts run smoothly.
Use clamps or a vise to hold the workpiece
n
securely. This is safer than using your hand.
Follow the instructions for lubrication and
n
changing tools.
Keep handles dry, clean and free from oil and
n
grease.
Keep the push stick or handle for a push block at
n
the machine at all times, even when you are not
using them.
Do not cut rebates or grooves without fitting a
n
suitable guard, e.g. a tunnel-type guard, over the
saw table.
Use only the transport device for transporting the
n
machine.
While you are moving the machine it is best to
n
cover the top part of the blade, for example using
a guard.
Do not lose these safety instructions.
2. Layout and items supplied /
Installation tools / Assembly material
/ Supplied package
(Fig. 1-2)
2.1 Layout
1. Saw bench
2. Stop rail for parallel stop
3. Parallel stop
4. Clamp lever for parallel stop
5. Guide rail for parallel stop
6. Push stick
7. Crank handle for saw blade height
8. Fixing handle for saw blade angle
9. ON/OFF/Emergency Stop switch
10. Clamp handle for cross stop
11. Cross stop
12. Saw blade
13. Stop rail for cross stop
14. Adjustable limit stop
15. Sliding table
16. Auxiliary edging plate
17. Splitter
18. Saw blade guard
19. Extraction hose
20. Rubber legs
21. Chassis
22. Legs
23. Chip box
24. Push handles
25. Hook for tool
26. Mounting for extractor hose
27. Extractor adapter
28. Hose clips for extractor hose
2.2 Installation tools
29. Flange wrench
30. Wrench
31. Allen key
2.3 Assembly material
a
16 x Screws for legs (M10 x 20 mm)
b
16 x Washers for legs (M10)
c
16 x Spring rings for legs (M10)
d
16 x Nuts for legs (M10)
e
4 x Screws for chassis (M8 x 35 mm)
f
2 x Allen bolts for extractor hose holder (M8 x 20
mm)
g
4 x Screws for angle bracket (M8 x 20 mm)
h
14 x Washers (M8)
i
4 x Spring rings (M8)
j
8 x Nuts (M8)
k
4 x Metal brackets
l
4 x Spacers
GB
29
Tabla de contenido
