Hilti GX 100-E Manual De Instrucciones página 26

Magazine:
Nail pusher jammed
Magazine cannot be fitted Rubber buffer on the magazine
en
Tool cannot be pressed
against the work surface
(cycling movement)
Nosepiece doesn't engage Lockbutton broken or deformed
Leakage from the gas can Faulty interface between gas can and
or leakage at the interface valve head
between the can and the
valve head
Please send the tool to a Hilti repair center if these measures fail to remedy the problem.
22
Printed: 07.07.2013 | Doc-Nr: PUB / 5069872 / 000 / 00
Dirt or debris
Foreign objects
retaining piece is missing
Locking lever not turned all the way
down (90°)
Magazine empty, or possible only 1
or 2 nails in the magazine
Tool pressed against a foreign object
Plastic debris jammed in the
nosepiece
Nail pusher engaged in rearmost
position
Nail pusher jammed
Sleeve turned out of position, not
engaged
Gas can not fitted correctly in the
tool
Nail has slid forward in fastener
guide
Loose nails or foreign objects under
the cover
Clean from the outside.
Remove foreign objects from the outside.
Replace the rubber buffer.
Turn the locking lever all the way
down (90°).
Load the magazine.
Press the tool against an unobstructed
surface.
Remove plastic debris.
Release the nail pusher.
Free the nail pusher, clean the magazine /
remove foreign objects
Bring sleeve into correct position.
Fit the gas can correctly.
Remove the magazine and remove the
nail.
Remove the magazine, remove
foreign objects. Have the tool
repaired at a Hilti repair center.
Fit a replacement nosepiece. Have the tool
repaired at a Hilti repair center.
Remove the gas can, remove the valve
head from the can and dispose of both
parts. Use a new gas can fitted with a
new valve head.