Prior To Operation - DeWalt D28111S Manual De Instrucciones

All manuals and user guides at all-guides.com
FIG. 4
N
Mounting the Side Handle (Fig. 4)
Screw the side handle (E) tightly into one of the holes (N) on either
side of the gear case.
OPERATION
WARNING: Allow the tool to reach full speed before touching tool
to the work surface. Lift the tool from the work surface before
turning the tool off.
WARNING: Ensure all materials to be ground or cut are secured
in place.
WARNING: Apply only a gentle pressure to the tool. Do not exert
side pressure on the disc.
WARNING: Avoid overloading. Should the tool become hot, let it
run a few minutes under no load condition.

PRIOR TO OPERATION

Install the guard and appropriate disc or wheel. Do not use
excessively worn discs or wheels.
Be sure the inner and outer flange are mounted correctly.
Make sure the disc or wheel rotates in the direction of the arrows
on the accessory and the tool.
Paddle Switch
WARNING: Before connecting the tool to a power source
N
depress and release the paddle switch (A) once without depressing
the lock-on button (B) to ensure that the switch is off. Depress and
release the paddle switch as described above after any interruption
E
in power supply to the tool, such as the activation of a ground fault
interrupter, throwing of a circuit breaker, accidental unplugging, or
power failure. If the paddle switch is locked on, the tool will start
unexpectedly when it is reconnected.
To turn the tool on, push the lock-off lever (B) toward the back of
the tool, then depress the paddle switch (A). The tool will run while
the switch is depressed. Turn the tool off by releasing the paddle
switch.
WARNING: Do not disable the lock-off lever. If the lock-off lever
is disabled, the tool may start unexpectedly when it is laid down.
WARNING: Do not switch the tool on or off when under load.
Metal Applications
When using the tool in metal applications, make sure that a residual
current device (RCD) has been inserted to avoid residual risks
caused by metal swarf.
If the power supply is shut off by the RCD, take the tool to authorised
D WALT repair agent.
E
WARNING: In extreme working conditions, conductive dust can
accumulate inside the machine housing when working with metal.
This can result in the protective insulation in the machine becoming
degraded with a potential risk of an electrical shock.
10