A) Composition; B) Technical Information - Roca ATAI Manual De Montaje Y Uso

TECHNICAL INFORMATION:
Composition (fig. A)
1. handle
2. screw
3. sliding disc
4. teflon ring
5. rod cap
6. cartridge O-ring
7. cartridge
8. bushes
9. springs
10. internal body
Supply
Hot water temperature
Working pressure
If working pressure is over 5 BAR, we recommend using a pressure reducer. This tap
is not compatible with the use of low-pressure instantaneous hot water heaters.
TIPS ON INSTALLATION:
Important: the hot water must be connected to the left pipe, the cold water to
the right pipe.
INSTALLATION:
After shutting off the mains, disassemble the old tap.
Clean the threads of the mains very well.
Instructions for correct installation:
Fig. D
Position onto the eccentric shank -21- from the bent side G1/2" - some teflon or other
material that will guarantee the seal between the wall attachments and the shank.
Fig. E
Screw the eccentric shanks -21- into their housings to the same depth, maintaining a
distance between centres of 150 mm (max. misalignment of wall attachments is +/-
16 mm). Make sure that the two shanks are aligned so that the tap will be perfectly
positioned.
Fig. F
Fit the rings -20- onto the circular part of the shanks -21-.
11. O-ring
12. O-ring
13. external body
14. cap
15. O-ring
16. housing
17. seal
18. seal
19. cover
20. ring for eccentric shank
Recommended
65°
3 BAR
17
21. eccentric shank
22. dowel
23. lower cap
24. shunt
25. O-ring
26. aerator fitting
27. aerator
28. flexible
29. duplex
30. shower
Maximum
80°
5 BAR
Minimum
15°
0.5 BAR