Roca ATAI Manual De Montaje Y Uso página 20

REPLACING THE SHUNT (Fig. C):
In case of a malfunction, unscrew the threaded fitting -24.9- with a hexagonal wren-
ch (ES12), remove the snap ring -24.7- with a 2 mm screwdriver. Pull the knob
upwards -24.1- be careful not to lose the parts which will be automatically disas-
sembled, i.e., the two washers -24.5- the seal -24.6- and the spring -24.4- . To
assemble, reverse the procedures after carefully cleaning the seals and applying a
thin film of lubricating grease, if needed.
REPLACING THE AERATOR (Fig. C):
To disassemble the aerator -27-, unscrew the ring nut -27.3- and clean the filter -
27.2- from any impurities. Fit back the aerator by carrying out the procedures in rever-
se, taking care to position the seal -27.1- correctly.
19