A) Composition; B) Technical Information; C) Installation - Roca ATAI Serie Montaje Y Uso

TECHNICAL INFORMATION:
Composition (fig. A)
1. handle
2. screw
3. sliding disc
4. teflon ring
5. rod cap
6. tap body
7. aerator
8. O-ring
9. O-ring + ring nut
10. O-ringt
11. cartridge
Supply
Hot water temperature
Working pressure
If working pressure is over 5 BAR, we recommend using a pressure reducer. This tap
is not compatible with the use of low-pressure instantaneous hot water heaters.
TIPS ON INSTALLATION:
Important: the hot water must be connected to the left pipe, the cold water to
the right pipe.
INSTALLATION:
After shutting off the mains, disassemble the old tap.
Clean the threads of the mains very well.
Instructions for correct installation:
Fig. D
First mount on the body the stud bolt -20- and the supply tubes -25- and tighten them
with an adjustable wrench (not included). Position the O-ring -19- in its housing on the
tap body.
Fig. E
Insert the tap into the hole in the fixture. Place the stud bolt -20- and the flange -22-
on the shaped seal -21- then tighten the tap with the stay -23-.
12. bushes
13. springs
14. O-ring
15. O-ring
16. O-ring
17. O-ring
18. internal body
19. seal
20. stud bolt
21. seal
22. flange
Recommended
65°
3 BAR
17
23. stay
24. supply tubes
25. vertical rod
26. clamp
27. horizontal rod
28. drain body
29. seal
30. tapered seal
31. drainl
32. cap
Maximum
80°
5 BAR
Minimum
15°
0.5 BAR