Electrical Requirements - Wolf E Serie Manual Del Usuario

SPECIFICATIONS
Electrical
Installation must be electrically grounded in accordance
with local codes or, in the absence of local codes, with the
National Electrical Code, ANSI/NFPA 70.
Locate the electrical supply flush with the back wall and
within the shaded area shown in the illustration for your
specific installation on the following pages. For ease of
installation, the electrical supply for the oven can be placed
in an adjacent cabinet within reach of the conduit. Use only
the conduit supplied with this appliance.
Performance may be compromised if the electrical supply is
less than 240 volts.
The wiring diagram covering the control circuit is provided
with the oven.

ELECTRICAL REQUIREMENTS

SINGLE OVEN
Electrical Supply
Service
Total Amps
Max Connected Load
Min Supply Wire
DOUBLE OVEN
Electrical Supply
Service
Total Amps
Max Connected Load
Min Supply Wire
RATING
PLATE
Rating plate location.
grounded, 240/208 VAC, 60 Hz
30 amp dedicated circuit
21
5.1 kW
L1, L2, ground—10 AWG
grounded, 240/208 VAC, 60 Hz
50 amp dedicated circuit
37
8.9 kW
L1, L2, ground—10 AWG
WARNING
The complete appliance must be properly grounded at
all times when electrical power is applied.
Grounding through the neutral conductor is prohibited
for new branch-circuit installations (1996 NEC); mobile
homes and recreational vehicles, or where local codes
prohibit grounding through the neutral conductor.
If aluminum house supply wiring is utilized, splice the
appliance copper wire to the aluminum house wiring
using special connectors design and agency certified
for joining copper and aluminum. Follow the connector
manufacturer's recommended procedure carefully.
Improper connection can result in a fire hazard.
|
wolfappliance.com 5