Black and Decker BD200MT Manual De Instrucciones página 7

Multiherramienta oscilante de 2,0 amperios
Ocultar thumbs Ver también para BD200MT:
Tabla de contenido
Idiomas disponibles

Idiomas disponibles

• Slide the accessory between the shaft
and the accessory holder making sure the
2
accessory engages all eight pins on the
holder and is flush with the shaft (figure 2.
• Release the accessory clamp lever.
• Some accessories, such as scrapers
and blades can be mounted at an angle if
3
required as shown in figure 3.
Installing/Removing Sanding
A triangle shaped base, or platen, uses a
Sheets - Figure 4
hook and loop adhesion system to attach
the sanding sheets.
4
• Attach the sanding platen as described
under "Installing/Removing Accessories".
• Align the edges on the sanding sheet,
with the edge of the sanding platen and
press the sanding sheet onto the platen.
• Firmly press the base with the sanding
sheet attached against a flat surface and
briefly switch the tool on. This provides
for good adhesion between the platen
and the sanding sheet and also helps to
prevent premature wear.
• When the tip of the sanding sheet
becomes worn, detach the sheet from the
platen, rotate and reapply.
7
Tabla de contenido
loading

Tabla de contenido