Safety Information; Package Contents - VWR isiScope 800 Serie Manual De Instrucciones

Warning
This microscope is a scientific precision instrument designed to last for many years with a minimum of main-
tenance. It is built to high optical and mechanical standards and to withstand daily use.
We remind you that this manual contains important information on safety and maintenance, and that it must
therefore be made accessible to the instrument users.
We decline any responsibility deriving from incorrect instrument use that does not comply with this manual.

Safety Information

Avoiding Electrical Shock
Before plugging in the power supply, make sure that the supplying voltage of your region matches with the
operation voltage of the equipment and that the lamp switch is in off position.
Users should observe all safety regulations of the region. The equipment has acquired the CE safety label.
However, users have full responsibility to use this equipment safely.
Please follow the guidelines below, and read this manual in its entirety to ensure safe operation of the unit.

Package Contents

DESCRIPTION
Microscope stand with nosepiece, stage
Optical head (trinocular)
Objective 4x
Objective 10x
Objective 20x (ONLY in -PH model)
Objective 40x
Objective 60x (NOT in -PH model)
Objective 100x
Eyepiece WF10x/22mm
Phase contrast condenser (ONLY in -PH model)
Centering telescope (ONLY in -PH model)
0,90 N.A. Swing-Out Condenser (NOT in -PH model)
Green filter, 45mm diameter (ONLY in -PH model)
Unpacking
The microscope is housed in a moulded Styrofoam container. Remove the tape from the edge of the contain-
er and lift the top half of the container. Take care to ensure that the optical items (objectives and eyepieces)
do not fall out and get damaged. Using both hands (one around the neck and one around the base), lift the
microscope from the container and put it on a stable desk.
Place the observation head onto the top of the neck and tighten the lock-screw. Insert the eyepieces into the
eye tubes.
Connect the provided power supply to the power supply input jack on the rear of the microscope.
QUANTITY
1
1
1
1
1
1
1
1
2
1
1
1
1
3