Before Taking Into Use; Information About The Batteries; Installation Of The Wall Holder - Silvercrest SAS 7.4 LI B1 Instrucciones De Uso

Before taking into use

• Remove all packaging materials from the
appliance.
• Place the dirt container q onto the motor block:
• Slide the plastic tab on the underside of the
handheld vacuum cleaner into the recess in the
dirt container q.
• Press the unlocking button 8 and slide the dirt
container q onto the motor block at the same
time.
• Let go of the unlocking button 8 so that the lok-
king mechanism engages in the recess.
The dirt container q is now sitting securely on
the motor block.

Information about the batteries

1. This hand-held vacuum cleaner is powered by
rechargeable lithium-ion batteries.
Before using the cableless hand vacuum cleaner
for the first time, the batteries must be charged
for at least 24 hours.
2. The batteries reach their full capacity after a
charging period of 24 hours. For care of the bat-
teries we recommend the following: after the bat-
teries are charged, remove the power adapter 4
from the mains power socket. Reconnect the
power adapter 4 again with the mains power
socket when the suction power of the appliance
is noticeably weaker.

Installation of the wall holder

Mortal danger!
Ensure that there are no power cables or other con-
duits or pipes in the wall at the location where you
intend to bore the holes for the wall holder 3.
It would be a potentially fatal risk to bore into a
current carrying electric cable!
1. Place the barrel plug 5 of the power adapter 4
into the wall holder 3 as shown in the diagramme.
Secure the barrel plug 5 by turning it.
2. Select a suitable installation location for the wall
holder 3: It should present no problem with
taking the hand vacuum cleaner out of it and a
mains power socket for the power adapter 4
must be accessible.
3. Bore two holes with a spacing of approx. 62 mm.
Use the wall holder 3 to mark the boreholes:
this will ensure the spacing is correct. The bore-
holes must be suitable for 5 mm wallplugs.
4. Insert the wallplugs into the boreholes and, using the
screws, firmly screw the wall holder 3 to the wall.
5. You can place the nozzles on the lateral acces-
sories holder.
6. Connect the power adapter 4 to a mains power
socket.
- 29 -