Before First Use; Fitting The Wall Bracket - Silvercrest SHAZ 22.2 B2 Instrucciones De Uso

Before first use

♦ Remove all packaging materials and any protective films from the device .
♦ Fit the wall bracket f as described in the section "Fitting the wall bracket" .
♦ Press the HEPA filter i and the filter holder z a little way into the dirt
container t . These may have worked loose during transport and thus
not be positioned correctly inside the dirt container t .
♦ Place the dirt container t on the hand element 4:
–
Push the plastic tab on the underside of the dirt container t into the
recess on the hand element 4 . Allow the "MOVE" u release button
on the upper side of the dirt container t to click audibly into the catch
on the hand element 4 .
NOTE
► To remove the dirt container t from the hand element 4, push the
"MOVE" u release button downwards and remove the dirt container t .
♦ Push the suction pipe 6 onto the hand element 4 so that the contact pins
on the suction pipe 6 slide into the socket on the hand element 4 .
The "PUSH" 5 release button should click audibly into place .
♦ Attach the floor nozzle 8 onto the suction pipe 6 in the same way .
NOTE
► To remove the suction pipe 6 or the floor nozzle 8 again, press the
respective "PUSH" 5/7 release button and pull the corresponding parts
apart .
♦ Place the appliance onto the wall bracket f and then put it into a corner or
lay it flat on the floor so it cannot tip over .

Fitting the wall bracket

DANGER – ELECTRIC SHOCK!
► Before drilling, ensure that there are no electrical cables or water pipes in the
wall . Drilling into a live electric cable can be potentially fatal!
♦ Push the accessories holder d onto the appropriate slots on the wall
bracket f .
■ 56 │ GB │ MT SHAZ 22.2 B2