Una Targa Citofonica; Una Targa Da Incasso Parete - Vimar ELVOX 68IA/R Instrucciones Instalador

Ocultar thumbs

página de 52

/ 52
Contenido
Tabla de contenido

Tabla de contenido

Idiomas disponibles

Installation of entrance panel (type 13K1), flush-mounting version

- Install the flush-mounting back box (D) on the wall with the bottom edge at

a height of approx. 1.65m from the ground

- Open the entrance panel by undoing the screw under the plate (G) and

detach the camera (B) from the frame, removing the light diffuser (h) and

the microphone (I).

- Fit the frame (C) to the flush-mounting back box (D)

- Reposition the camera in the frame and the microphone in the special

housing, refitting the plug as shown in fig.16A.

- Connect the camera to the name card lighting LED board using the two

cable harnesses (harness with red/black wire for LED power supply and

harness with two green wires for connection of a second call button, if

required) fig.16B.

- Make the connections to the installation on the removable terminal block

(L). In the case of installation for two-family video door entry systems:

- Remove the blanking module (E) fig. 17, from the back of the plate using

a screwdriver, working in sequence from bottom to top (first remove the

end section, then key 1 and finally the blanking module).

MATERIALE NON FORNITO DI SERIE DA ORDINARE SEPARATAMENTE PER PREDISPORRE

- Fit the external key (F) (supplied) to the plate by pushing it lightly into

ESECUZIONE DA INCASSO PARETE

place.

- Insert the light diffuser (h) to ensure even lighting of the name cards.

- Close the entrance panel, securing it to the frame with the aid of a screw-

driver.

MATERIALE NON FORNITO DI SERIE DA ORDINARE SEPARATAMENTE PER PREDISPORRE

Fig.15

MATERIALE NON FORNITO DI SERIE DA ORDINARE SEPARATAMENTE PER PREDISPORRE

Fig.16A