Safety Notes; Adverse Reactions; Step-By-Step Instructions - DENTSPLY AutoMatrix Snippers+ Manual De Usario

2

Safety notes

Be aware of the following general safety notes and the special safety notes in other
chapters of these Instructions for Use.
2.1 Warnings
• None.
2.2 Precautions
These products are intended to be used only as specifically outlined in these Instruc-
tions for Use.
Any use of these products inconsistent with these Instructions for Use is at the discre-
tion and sole responsibility of the dental practitioner.
• AutoMatrix
dure given [4 Hygiene] prior to (first) use or storage.
• Use protective measures for the dental team and patients such as glasses and rub-
ber dam in accordance with local best practice.
• Prior to application, make sure that the Catch-Tray is properly connected to the
Snippers
Snippers
• After clipping, immediately retrieve any loose part and remove from mouth.

2.3 Adverse reactions

• None known.
3

Step-by-step instructions

3.1 Preparation of AutoMatrix
1. Attach Catch-Tray from the left side to the Snippers
into the nut below the bolt head. Turn the Catch-Tray of 90° in the instrument axis of
the Snippers
2. Make sure that the pin on the lower surface of the Catch-Tray clicks in the hole upon
the upper side of the blade edge.
3. Before application, make sure that the Catch-Tray is properly connected to the
Snippers
Snippers
K100404-00 AutoMatrix Snippers+.indd 3
Safety alert symbol.
• This is the safety alert symbol. It is used to alert you to potential
personal injury hazards.
• Obey all safety messages that follow this symbol to avoid possible
injury.
Snippers should be cleaned and disinfected according to the proce-
® +
: Turn instrument and check that there is no gap between Catch-Tray and
+
(Figures 2, 3 and 4). Make sure that the Catch-Tray is empty.
+
Snippers
®
(Figure 1).
+
Displacement of Catch-Tray.
After clipping, do not open AutoMatrix
prevent displacement of Catch-Tray, which may cause leakage of the
Catch-Tray and release of cut pieces.
: Turn instrument and check that there is no gap between Catch-Tray and
+
(Figures 2, 3 and 4). Make sure that the Catch-Tray is empty.
+
+
by sliding the u-shaped cavity
+
Snippers more than 60° to
® +
3
14.08.14 09:08