Washing The Filter - Flex FX5221 Manual Del Operador

WARNING
assembly, adjustments or changing
accessories. Such preventive safety measures
reduce the risk of starting the appliance
accidentally.
FILTER CLEANING SYSTEM (FIG. 12)
The device is equipped with a semi-automatic
filter cleaning system. It cleans the filter and
restores the suction power.
To use the filter cleaning system:
a. Switch the vacuum cleaner on.
b. Make sure that the suction regulator is set to
the maximum suction (Fig. 6).
c. Insert the nozzle pipe into the special recess
on the head unit to block the air flow and to
generate the maximum vacuum in the dust
canister.
d. Press the filter cleaning button three times to
clean the filter.

WASHING THE FILTER

Periodically examine the filter by lifting the head
unit (Fig. 3). If the filter is still dirty after following
REPLACING THE FILTER (FIG. 13)
WARNING
damaged. Using damaged filter can lead to
release of unwanted airborne contaminants
from the canister.
To remove the filter:
a. Lift the head unit (Fig. 3) and put it on its side.
b. Loosen the screw and remove the filter and
the filter holder.
c. Before installing the new filter, use a moist
piece of cloth to remove any dust and debris
from the filter area.
d. Install the new (or cleaned) filter in the
reverse order of removal. Do not overtighten
the screw!
ADJUSTMENTS
Detach the battery pack
before making any
Check the filter periodically
and replace if worn out or
Fig. 12
1
ON
the steps in the FILTER CLEANING SYSTEM
chapter, remove it. Rinse it in cold water. Allow
the filter to dry completely and reinstall it.
Fig. 13
1
-15-
2
2