Troubleshooting - Kohler Sterling 7726 Serie Manual De Instrucciones

Warranty (cont.)
replacement or an equivalent model (in those cases that the model has been discontinued) when the product
is beyond repair, without any charge to the consumer.
4. The time of repair will not exceed six (6) weeks commencing on the date the product is received.
5. It is recommended that the consumer save the invoice or receipt as additional protection, as it may
substitute the warranty in the case that there is a discrepancy in the validity of the warranty.
EXCEPTIONS AND RESTRICTIONS
The Warranty will not be valid in the following cases:
1. When the product is not operated in accordance with the instructions concerning use and operation set
forth in the owner's manual or installation instructions, and when the recommendations and warnings
included are not observed.
2. When the product has been modified or dismantled partially or totally; or has been used in a negligent
fashion and as a consequence has suffered damages attributable to the consumer, individual, or hardware not
authorized by Kohler Co.
3. This warranty does not cover the damages as a result of disaster such as fire or acts of God, including
flooding, earthquake, or electric storms, etc. To obtain a list of distributors in your area where you can
exercise your rights under this warranty, please call 001-877-680-1310.
KOHLER CO., KOHLER, WI 53044 U.S.A.
IMPORTER:
INTERNACIONAL DE CERÁMICA, S.A.B. DE C.V.
AV. CARLOS PACHECO NO. 7200
CHIHUAHUA, CHIH., MEXICO C.P. 31060
TEL: 52 (14) 29-11-11

Troubleshooting

This troubleshooting guide is for general aid only. A Sterling Authorized Service Representative or
qualified electrician should correct all electrical problems. For warranty service, contact your dealer or
wholesale distributor.
If symptoms persist after the recommended action is taken or replacement parts are needed, refer to your
installer or dealer.
Symptoms
1. Blower motor does not
start/stop.
2. Blower motor starts, but
not all airjets are
functioning.
1139487-5-F
Probable Causes
A. No power to the blower motor.
B. Air switch does not work.
C. Blower motor does not work.
A. Airjets are blocked.
B. Insufficient voltage to the blower
motor.
Recommended Action
A. Reset the GFCI. Check the wiring.
B. Verify each end of the air tube, at
the air switch and at the blower
motor, is properly connected.
Inspect the tubing for kinks,
damage, or clogs. Replace the air
tube or air switch.
C. Replace the blower motor.
A. Remove the blockage.
B. Change blower speed profile to
increase air flow:
1. Unplug the blower from the GFCI
outlet.
2. Plug the blower back in.
6 Sterling