Tabla de contenido
Idiomas disponibles
Idiomas disponibles
Page 4
SbbI-2-670-C
Important: To ensure that this equipment reaches you in first class condition, protective coatings have
been used. Flush the equipment through with a suitable solvent before use.
1. Attach air hose to connector (26). Recommended hose
size 8 mm bore. The hose must be conductive and elec-
trical bond from the spraygun to earth should be
checked with an ohmmeter. A resistance of less than
10 6 ohms is recommended.
1. Mix coating material to manufacturers instructions.
2. Turn needle adjusting screw (22) counter-clockwise
until first thread shows.
3. Turn pattern valve (12) counter-clockwise to fully open.
4. Adjust inlet air pressure to give 2.1 bar (30 psi) at the
gun inlet with the gun triggered. (pressure gauge
attachment shown under Accessories is recommended
for this).
5. Test spray. If the finish is too dry, reduce air flow by
reducing inlet pressure. If finish is too wet, reduce fluid
flow by turning needle screw (18) clockwise. If atomi-
sation is too coarse, increase inlet air pressure. If too
fine, reduce inlet pressure.
1. Turn off air supply and relieve pressure in the airline or,
if using QD system, disconnect from airline.
2. Empty coating material into a suitable container and
clean the gun and cup, preferably in a gun wash
machine.
3. IMPORTANT– the cup must not be cleaned or rubbed
with a dry cloth or paper. It is possible to generate a
static charge by rubbing which, if discharged to an
earthed object, could create an incentive spark and
cause solvent vapours to ignite. Only use a dampened
cloth or antistatic wipes if additional cleaning is
required within a hazardous area.
WaRRaNTy
This product is covered by DeVilbiss' 1 Year Limited Warranty.
Devilbiss Worldwide Sales and Service listing: www.autorefinishdevilbiss.com
Devilbiss automotive Refinishing
DeVilbiss has authorized distributors throughout the world.
For equipment, parts and service, check the Yellow Pages
under "Automotive body Shop Equipment and Supplies."
For technical assistance, see listing below.
u.S./Canada Customer Service Office:
11360 S. Airfield Road, Swanton, OH 43558
Toll-Free Telephone: 1-800-445-3988 (U.S.A. and Canada only)
Toll-Free Fax: 1-800-445-6643
INSTallaTION
OPERaTION
PREvENTaTIvE maINTENaNCE
2. Air supply should be filtered and regulated.
6. The pattern size can be reduced by adjusting valve (10).
7. Hold gun perpendicular to surface being sprayed.
Arcing or tilting may result in uneven coating.
8. The recommended spray distance is 150-200 mm
(6"-8").
9. Spray edges first. Overlap each stroke a minimum of
50%. Move gun at a constant speed.
10. Always turn off air supply and relieve pressure when
gun is not in use.
4. Remove air cap (2) and clean. If any of the holes in the
cap are blocked with coating material, only use the
cleaning kit 192212 (see accessories) which has the
correct tools for this, or a toothpick to clean. Using any
other tool could damage the cap and produce distorted
spray patterns.
5. Ensure the tip of the nozzle is clean and free from
damage. build-up of dried paint can distort the spray
pattern.
6. Lubrication – Trigger stud (3), needle (25) and air-valve
spindle (13) should be oiled each day.
4/12 ©2012 binks All rights reserved. Printed in U.S.A.
Tabla de contenido
