Espa SPEEDRIVE V2 Manual Del Usuario página 19

DRY RUNNING
ERROR
UNDER VOLTAGE
ERROR
GROUND DERIVAT.
ERROR
PHASE MOTOR
ERROR
PHASE IN
ERROR
ERROR
TEMP. MODULO
*= Illustration of the sequence and times of the 4 attempts, if not none of them succeed:
DRY RUNNING DRY RUNNING
DRY RUNNING DRY RUNNING
If a pump runs for more than 10 seconds without water, the unit stops.
The reset is automatic. If the error is not solved 4 new attempts* are performed.
If the error is still present after the fourth attempt, the system will be set to a
permanent fault.
Before resetting, ensure that the pump is correctly primed again.
Press OK to reset. The start screen (#2) will appear. Press OK to reset. The start screen (#2) will appear. Press OK to reset. The start screen (#2) will appear. Press OK to reset. The start screen (#2) will appear.
LOW VOLTAGE IN THE MODULE LOW VOLTAGE IN THE MODULE
LOW VOLTAGE IN THE MODULE LOW VOLTAGE IN THE MODULE
The power module protects itself against internal voltage drops.
Press OK to reset. Press OK to reset. Press OK to reset. The start screen (#2) will appear. Press OK to reset. The start screen (#2) will appear. The start screen (#2) will appear. The start screen (#2) will appear.
ERROR DUE TO EARTH LEAKAGE IN THE ENGINE ERROR DUE TO EARTH LEAKAGE IN THE ENGINE
ERROR DUE TO EARTH LEAKAGE IN THE ENGINE ERROR DUE TO EARTH LEAKAGE IN THE ENGINE
Earth leakage has been detected in one of the engine phases.
The unit stops.
Before resetting, make sure that the engine malfunction has been repaired.
Press OK to reset. The start screen (#2) will appear. Press OK to reset. The start screen (#2) will appear. Press OK to reset. The start screen (#2) will appear. Press OK to reset. The start screen (#2) will appear.
ERROR DUE TO MOTOR PHASE FAILURE ERROR DUE TO MOTOR PHASE FAILURE
ERROR DUE TO MOTOR PHASE FAILURE ERROR DUE TO MOTOR PHASE FAILURE
It has been detected that one of the engine phases is disconnected or consuming
very little.
The unit stops.
Before resetting, make sure that the engine malfunction has been repaired.
Press OK to reset. The start screen (#2) will appear. Press OK to reset. The start screen (#2) will appear. Press OK to reset. The start screen (#2) will appear. Press OK to reset. The start screen (#2) will appear.
PHASE FAILURE AT THE CURRENT INPUT PHASE FAILURE AT THE CURRENT INPUT PHASE FAILURE AT THE CURRENT INPUT PHASE FAILURE AT THE CURRENT INPUT
A phase failure at the current input has been detected.
It automatically resets. It will retry 4 times*.
If the error persists after the fourth try, the unit will go into permanent failure.
Before resetting, check the current input connections.
Press OK to reset. The start screen (#2) will appear. Press OK to reset. The start screen (#2) will appear.
Press OK to reset. The start screen (#2) will appear. Press OK to reset. The start screen (#2) will appear.
EXCESSIVE MODULE TEMPERATURE EXCESSIVE MODULE TEMPERATURE EXCESSIVE MODULE TEMPERATURE EXCESSIVE MODULE TEMPERATURE
Overheating of the power module. This is an internal cooling failure.
The unit stops. Press OK to reset.
If the problem persists, it can only be repaired by an official technical service.
1'
5' 15'
ON
OFF
1º 2º
- 19 -
60'
3º 4º