Installation Conditions - Mestra R-100191 Manual De Instrucciones

English
RESPONSABILITY LIMITATION
1. Manufacturer shall
responsibility if any malfunction, damage or
accident if it is caused by the improper
renoval, modification,
repair as not being conducted by the dealer
designated by us.
2. Manufacturer shall
responsibility if any malfunction, damage or
accident if it is caused by the use of the
product not provided by us.
3. Manufacturer shall
responsibility if any malfunction, damage or
accident if it is caused by the improper
removal, modification,
repair as not use the parts provided by us.
4. Manufacturer shall
responsibility if any malfunction, damage or
accident if it is caused by the improper
operation as not in compliance with the
manual.
5. Manufacturer shall
responsibility if any malfunction, damage or
accident if it is caused by the ambient
environment as not in compliance with the
power, installation environment and using
conditions specificied on this manual.
6. Manufacturer shall
responsibility if any malfunction, damage or
accident if it is caused by fire disaster,
earthquake, flood or strock by lightning.

INSTALLATION CONDITIONS

1. Conditions for installation and using
place:
• Use inside the house.
• Use at the ambient temperature between 5º
C - 40º C.
• Use a 230 V, 50/60 Hz power source.
2. Installation:
• Install on the cabinet or table strong and
firm with flan surface, thw strength of which
is sufficient to support.
• Never install near inflamable substances.
12
not assume any
maintenance, or
not assume any
not assume any
maintenance or
not assume any
not assume any
not assume any
3. Before / after transpor:
• Before installation, remove the 2 bolts
fixed at the bottom of the machine (Fig.
1) and place them in the holes at the
back of the unit for future use.
• If the mixer is out of order and needs to
be sent for repair or delivered to some
far place, please fasten by the fixing
bolts attached in the delivery, otherwise
it could possibly
malfunction or damage.
! NOTE
There is a new desing of rear cover where
the bottom screws can fix.
4. Power
• Connect the powr cable to the outlet on the
reverse side of the machina.
• Connect to a 230 V, 50/60 Hz grounded
power source.
cause further
Fig. 1
Fig. 2