Installation; Maintenance & Servicing; Intended Use; Equipment Disposal - VWR Mini Auto Stirrer Manual De Instrucciones

I
NstaLLatIoN
Upon receiving the VWR Mini Auto Stirrer, check to ensure that no damage has
occurred during shipment. It is important that any damage that occurred in transport is
detected at the time of unpacking. If you do find such damage the carrier must be noti-
fied immediately.
After unpacking, place the Mini Auto Stirrer on a level bench or table, away from explo-
sive vapors. Ensure that the surface on which the unit is placed will withstand typical
heat produced by the unit. Always place the unit on a sturdy work surface.
The Mini Auto Stirrer is supplied with a 3-prong power cord that should be plugged into
a standard 3-prong grounded outlet. If the cord supplied does not meet your needs
please use an approved power cord that suits local codes and electric supply.
Replacement of the plug must be made by a qualified electrician.
M & s
aINtENaNCE ErvICINg
The Mini Auto Stirrer is built for long, trouble-free, dependable service. No lubrication
or other technical user maintenance is required. The unit should be given the care nor-
mally required for any electrical appliance. Avoid wetting or unnecessary exposure to
fumes. Spills should be removed promptly.
Do Not use a cleaning agent or solvent on the front panel which is abrasive or harm-
ful to plastics, nor one which is flammable. Always ensure the power is disconnected
from the unit prior to any cleaning. If the unit ever requires service, contact your VWR
representative.
I U
NtENDED sE
The Mini Auto Stirrer is intended for general laboratory use.
E D
qUIPMENt IsPosaL
This equipment must not be disposed of with unsorted waste. It is
your responsibility to correctly dispose of the equipment at life-cycle-
end by handing it over to an authorized facility for separate collection
and recycling. It is also your responsibility to decontaminate the equip-
ment in case of biological, chemical and/or radiological contamination,
so as to protect the persons involved in the disposal and recycling of
the equipment from health hazards.
For more information about where you can drop off your waste of equipment, please
contact your local dealer from whom you originally purchased this equipment. By doing
so, you will help to conserve natural and environmental resources and you will ensure
that your equipment is recycled in a manner that protects human health.
E C
NvIroNMENtaL oNDItIoNs
operating Conditions: Indoor use only.
Temperature: 5 to 40°C
Humidity: 20% to 85% relative humidity, non-condensing
Altitude: 0 to 2000 M above sea level
Non-operating storage:
Temperature: -20 to 65°C
Humidity: 20% to 85% relative humidity, non-condensing
Installation Category II and Pollution Degree 2 in accordance with IEC 664.
EN
2