Idiomas disponibles
Idiomas disponibles
Verifying latch operation
15. Swing the gate closed. The only slight
resistance you should feel is when the upper
and lower latch spindles swing into the latches
with the end of the spindles dropping
automatically into the latch cups.
(See figure 15).
16. Place the hinge pins (P/N 8) on both the upper
and lower hinges as shown in figure 16. Press
the hinge pins lightly against the mounting
surface and downwards to make sure that the
hinge pins are located correctly. Secure the top
and bottom hinge pins in place with screws
(P/N 15).
17. Tighten all spindle locknuts with provided
wrench (P/N 12). Fully tighten all screws,
including the screws in the upper and lower
panel assembly fittings shown in figure s 3 & 4.
P/N 8
P/N 15
P/N 9
Page 7
