Battery Test - Facom BAT.TEST Manual Del Usuario

BATTERY TEST

1. Press the key to select Battery Test. In this
stage, you will find the 3 tests for selection below.
START-STOP TEST
BATTERY TEST
SYSTEM TEST
Press «ENTER» button to proceed the test for regular starting battery.
2. Press the key to select battery type:
a. REGULAR FLOODED
b. AGM FLAT PLATE
c. AGM SPIRAL
d. VRLA/GEL
3. Press the key to select battery rating:
SAE (CCA), EN, IEC, DIN or JIS. Press «ENTER»
to confirm choice.
4. Press the key to input the battery capacity:
SAE (CCA): 40~2,000
EN: 40~2,100
DIN: 25~1,300
IEC: 30~1,500
JIS: Battery Type No.
5. Press the key to confirm the position of
the battery if the surface charge is detected.
Follow the tester 's steps to remove the surface
charge if it happens. Then testing proceeds.
Press «ENTER» to confirm choice.
Press «ENTER» to begin test.
- 8 -
BATTERY TEST
XX.XXV
BATTERY TYPE
AGM FLAT PLATE
SELECT RATING
SAE
SET CAPACITY
XXXX SAE
TEST IN VEHICLE?
NO