Installing The Electric Components - Festo HGPLE-25-40 Instrucciones De Utilizacion

HGPLE

Installing the electric components

Protecting the end positions against uncon
trolled startup:
Take into consideration the fact that
S
software end positions in the SFC−DC con
troller can be set.
Make sure that the controller is switched
S
off.
It is not sufficient just to cancel the enable
signal to the controller.
Wire the HGPLE to the controller at connection 5.
S
Use the permitted connecting cable as specified in our catalogue.
S
www.festo.com/catalogue
Pin Connection
1 Motor +
2 Motor −
3 A
4 A/
5 B
6 B/
7 I
8 I/
9 +5 V DC (±5 %)
10 GND
11 NC
12 NC
Fig. 5
Festo HGPLE 0805NH English
Designation
Motor conductor
Motor conductor
Encoder signal RS485
Encoder signal RS485
Encoder signal RS485
Encoder signal RS485
Encoder signal RS485
Encoder signal RS485
Signal supply
(max. 50 mA)
Signal ground
Pre−assigned
Pre−assigned
5
Fig. 4
Plug connector M12 on the HGPLE
(12−pin, view onto plug pins)
25