Festo CMMS-ST-C8-7-G2 Manual Del Usario página 30

Preparations for commissioning
1. Connecting the motor
2. Connecting the CMMS−ST stepping motor controller.
3. Connecting a PC.
4. Checking readiness to operate.
5. Install the parameterisation software on your PC
6. Follow the parameterisation software installation
instructions.
30
Make sure that the controller release switch is
switched off.
Switch on the power supply of all equipment.
The READY LED on the front of the equipment
should light up.
Place the data storage medium in the disk drive.
If the SETUP program does not start automatically,
start WINDOWS Explorer.
Switch to the disk drive containing the data storage
medium with the parameterisation software.
Run the SETUP.EXE program (double click).
.
Festo P.BE−K−CMMS−ST−G2 1008NH English