Charging The Battery - Hilti ST 1800­-A22 Manual De Instrucciones

Storage temperature
Battery charging starting temperature
5 Operation

5.1 Charging the battery

1. Before charging the battery, read the operating instructions for the
charger.
2. Make sure that the contacts on the battery and the contacts on the
charger are clean and dry.
3. Use an approved charger to charge the battery.
5.2 Inserting the battery
WARNING
Risk of injury! Inadvertent starting of the impact screwdriver.
▶ Before fitting the battery, check that the cordless impact screwdriver is
switched off and that the forward/reverse switch is in the middle position
(i.e. safety lock engaged).
WARNING
Electrical hazards! Risk of short circuiting.
▶ Before inserting the battery, check to ensure that the battery terminals
and the contacts in the impact screwdriver are free from foreign objects.
WARNING
Risk of injury! Hazard presented by a falling battery.
▶ A falling battery may present a risk of injury to yourself and others. Check
that the battery is securely seated in the power tool.
Make sure that the outer surfaces of the battery are clean and dry before
inserting the battery in an approved battery charger.
▶ Push the battery into the product from the rear as far as it will go and until
it is heard to engage with a double click.
5.3 Removing the battery
▶ Remove the battery.
*2153707*
Printed: 05.06.2019 | Doc-Nr: PUB / 5293039 / 000 / 04
2
3
2153707
−4 ℉ ... 104 ℉
(−20 ℃ ...
40 ℃)
14 ℉ ... 113 ℉
(−10 ℃ ...
45 ℃)
English 9